The Spot-Hogg side dial series of sights is a great all around Target-3D and hunting sight.  If ever there was a one sight does it all....this is it!

To make a perfect tape for this sight follow the directions below.

Multi-Pin with the rover pin. (TAP PRO)

Think of this as a two step process.

  1.  
  • Select your calculation method.  I prefer single speed myself, then two sight marks if the tape isn't perfect. This is for single speed.
  • Select Linear Sight...dont select Specialty for this step.
  • Enter your peep to pin and peep to arrow measurements.
  • Enter your bow and arrow information on their respective tabs.
  • Print your tape and align your pins to this sight tape.

If you are using sight marks then:

  • Select your sight by selecting 'Linear' then select 'Specialty Sights' then Spot Hogg Side Dial Series.
  • Enter your peep to pin and peep to arrow measurements.
  • Remove all your pins except the 'Rover'
  • Sight in a 30 and 70 (or whatever you are comfortable with)
  • in the Menu under options make sure to select 'Near Sight Mark' that matches what you shot in
  • Enter into the Calculation method form your near and far mark and the range for the far one.
  • Enter your bow and arrow information on their respective tabs.
  • Print your tape and align your fixed pins to this sight tape.  Remember to use the scale as a reference.

2.

  • If you used single speed for your fixed pins, now you can select 'Specialty Sights' and Spot Hogg Side Dial Series.
  • Print your tape and cut off whatever portion you dont need for fixed pins....
  • Set your rover to your reference point and affix your sight tape the dial aligning up with the rover pins setting....

If you used sight marks then:

  • Just put the sight tape on your dial with the rover pin as your starting reference point.  Example:  You have fixed 20-50.  Get your rover sighted into 60, cut the sight tape off at 60 or a little less.....then put this on aligning the point to this tape.

Single Pin. (TAP PRO)

  • Select your Calulation Method
  • Select your sight by selecting 'Linear' then select 'Specialty Sights' then Spot Hogg Side Dial Series.
  • Enter your peep to pin and peep to arrow measurements.
  • Remove all your pins except the 'Rover'
  • Sight in a 30 and 70 (or whatever you are comfortable with)
  • in the Menu under options make sure to select 'Near Sight Mark' that matches what you shot in
  • Enter into the Calculation method form your near and far mark and the range for the far one.
  • Enter your bow and arrow information on their respective tabs.
  • Print your tape and align your fixed pins to this sight tape.  Remember to use the scale as a reference.

With TAPes

There aren't any special considerations for this sight.  Just follow the directions starting at step one and you'll have a perfect Tape!